• <rp id="4rcvi"><acronym id="4rcvi"><input id="4rcvi"></input></acronym></rp>

    <ol id="4rcvi"></ol>

  • <rp id="4rcvi"></rp>
  • <button id="4rcvi"><object id="4rcvi"></object></button>

    中科聚峰礦井車設備

    • 服務熱線:

      15065707252

    當前位置:首頁 > 新聞中心 > 常見問題 >

    新聞中心

    服務熱線電話

    15065707252

    礦井裝載機如何地倒車?

    來源:http://www.acoderx.net/ 發布時間:2022-06-02 瀏覽次數:200

    內容詳情:
    礦井裝載機是電鏟裝載和短距離搬運的理想工具。那么,你知道礦井裝載機如何地倒車嗎?給大家做一個詳細的介紹。
    Mine loader is an ideal tool for shovel loading and short distance handling. So, do you know how to reverse the mine loader? Give you a detailed introduction.
    一、如何倒車
    1、 How to reverse
    (1) 礦井裝載機倒車時,車頭穿過的區域比車身占用的區域大得多,所以在注意車尾的同時,不要忽視左右兩端對車頭的觀察,尤其是此時通過車前的行人。
    (1) When reversing the mine loader, the area that the car head passes through is much larger than the area occupied by the car body. Therefore, while paying attention to the rear of the car, do not ignore the observation of the car head at the left and right ends, especially the pedestrians passing in front of the car at this time.
    (2) 靠近車輛側面的區域??拷囕v兩側的區域看不見,轉向時,前輪軌跡為圓弧,與后輪有輪差,倒車時可能劃傷。
    (2) The area close to the side of the vehicle. The area close to both sides of the vehicle cannot be seen. When turning, the track of the front wheel is circular arc, which is different from the rear wheel. It may be scratched when reversing.
    (3) 后擋風玻璃的下部。如果沒有輔助設備,倒車時該區域完全不可見。
    (3) The lower part of the rear windshield. If there is no auxiliary equipment, the area is completely invisible when reversing.
    (4) 如果有倒車雷達,當遇到一些較低的障礙物時,倒車雷達不能保證完全判斷。
    (4) If there is a reversing radar, the reversing radar cannot ensure complete judgment when encountering some low obstacles.
    (5) 注意車輛周圍的障礙物、車輛和人員。礦井裝載機有很大的視覺盲區。一定要倒車。
    (5) Pay attention to obstacles, vehicles and personnel around the vehicle. The mine loader has a big blind spot. Be sure to back up.
    礦井裝載機
    Mine loader
    (6) 檢查周圍是否有人,以確保。
    (6) Check whether there are people around to ensure that.
    二、預防措施
    2、 Preventive measures
    (1) 礦井裝載機工作時,不要鏟取大于車輛重量的物體。
    (1) When the mine loader is working, do not shovel objects larger than the weight of the vehicle.
    (2) 礦井裝載機在高溫下工作時,要注意水箱中的水,多觀察水溫,防止發動機高溫。
    (2) When the mine loader works under high temperature, pay attention to the water in the water tank and observe the water temperature to prevent the engine from high temperature.
    (3) 啟動前,觀察機器前后是否有障礙物和行人,按完喇叭后啟動。
    (3) Before starting, observe whether there are obstacles and pedestrians in front of and behind the machine, and start after honking the horn.
    (4) 行駛時,可根據路況選擇高速檔和低速檔。行駛中嚴禁吊起和翻轉鏟斗。
    (4) When driving, you can select high gear and low gear according to the road conditions. It is forbidden to lift or turn over the bucket during driving.
    (5) 行走時,盡量避免將鏟斗抬得太高。根據不同的土質采用不同的開挖方法,盡量從正面插入鏟斗,防止鏟斗單邊受力。
    (5) When walking, try not to lift the bucket too high. Different excavation methods shall be adopted according to different soil properties, and the bucket shall be inserted from the front as far as possible to prevent unilateral stress of the bucket.
    (6) 在松軟不平的場地作業時,將提升桿置于浮動位置,使鏟斗在平坦的地面上工作。
    (6) When working on a soft and uneven ground, place the lifting lever in the floating position to make the bucket work on a flat ground.
    三、礦井裝載機作業時應注意以下注意事項:
    3、 The following precautions shall be paid attention to during the operation of mine loader:
    1.剎車、喇叭、轉向器齊全靈敏,行車中遵守“交通規則”。如果你需要經常在高速公路上駕駛,司機須持有“機動車駕駛證”。
    1. the brake, horn and steering gear shall be complete and sensitive, and the "traffic rules" shall be observed during driving. If you need to drive frequently on the highway, the driver must have a "motor vehicle driving license".
    2.礦井裝載機與自卸車配合工作時,裝載時自卸車不得從鏟斗下方通過。
    2. when the mine loader works with the dump truck, the dump truck shall not pass under the bucket during loading.
    3.裝載機滿鏟斗運行時,鏟斗不應抬得太高,一般離地面約0.5m。
    3. when the loader is running with a full bucket, the bucket should not be raised too high, generally about 0.5m from the ground.
    4.裝載機行駛時應避免不適當的高速和急轉彎。
    4. avoid improper high speed and sharp turning when the loader is driving.
    5.當礦井裝載機遇到阻力變大、輪胎(或履帶)打滑、發動機轉速降低等現象時,應停止鏟裝,不得強行操作。
    5. when the mine loader encounters such phenomena as increased resistance, tire (or track) slipping, engine speed reduction, etc., it shall stop shoveling and loading and shall not be operated forcibly.
    礦井裝載機具有運行速度快、機動性好、操作輕便等優點。因此,它發展迅速,成為土方工程施工的主要機械。用于路基工程的填挖,瀝青和水泥混凝土堆場的骨料和裝載。
    The mine loader has the advantages of fast running speed, good mobility and light operation. Therefore, it has developed rapidly and become the main machinery for earthwork construction. It is used for filling and excavation of subgrade works, aggregate and loading of asphalt and cement concrete storage yard.
    本文的精彩內容由礦井裝載機提供知識提供,本網站還有很多的精彩內容,更多的內容您可以點擊進入http://www.acoderx.net我們有專門的客服為您解答問題
    The wonderful content of this article is provided by the knowledge provided by the mine loader. There are many wonderful content on this website. You can click to enter more content http://www.acoderx.net We have special customer service to answer your questions
    24小时韩国在线观看免费视频高清

  • <rp id="4rcvi"><acronym id="4rcvi"><input id="4rcvi"></input></acronym></rp>

    <ol id="4rcvi"></ol>

  • <rp id="4rcvi"></rp>
  • <button id="4rcvi"><object id="4rcvi"></object></button>